Automotive Paint Spray Booth Heat Recovery System Air Flow
1. With heat recuperation system, energy save and more efficiency.
2. 0.6mm coated steel with rock wool inside for wall panel.
3. Quality brand name turbo fans, directly drive type
4. Riello RG5S diesel burner with a heating productivity of
5. Pneumatic damper for spraying to baking cycle.
6. Double layer heat exchanger.
7. Siemens motors.
8. Electric damper for intake and exhaust, control the air flow.
In painting, outside fresh air comes into the heating generators
through the pre-filter system, and enters into the plenum, then
filtered by ceiling filter and into the both which brings clean,
symmetrical and steady-going down airflow for spraying,After
painting, Hot air goes from heating
generators to plenum, then enters room after filtered by ceiling
filter, providing heat that is necessary for baking of cars
surface. In the meantime, heat recuperation system start
working,energy save and temperature raise fast. Afterwards, the air
with little benzene will be released to the atmosphere after being
filtered twice by the exhaust air filter.
|Front door||Folding door,1 set, 3folds, 3000×2600 mm(W×H), bending main door,
|Emergency door||1 sets, 800×2000 mm(W×H), white color.|
|Basement||500mm basement, quadrate steel support, full grilles, twisted steel
and bar, galvanized, in the ground, no ramps, standard air
|Wall Panels||Thickness:50mm, width:1150mm, tongue and groove structure, 0.376mm
colour steel with PU insulation inside, colour: white.|
|Light||Ceiling Lights: 8Units×4Pcs=32Pcs×36W, side lights:
8Units×4Pcs=32Pcs×18W, with electronic ballasts, lighting boxes are
|Generator cabinet||On the top, intake from back upper, exhaust from back upper,
quadrate steel frame; white coated steel covered, filled with heat
preservation material inside.|
|Intake and Exhaust system||Inlet: 1×7.5KW centrifugal fan, belt drive, model: TAE-450H, air
capacity for each fan: 21000m3/h.|
|Outlet: 1×7.5KW centrifugal fan, belt drive, model: TAE-450H, air
capacity for each fan: 21000m3/h, with manual damper.|
|Heating system||Diesel burner RG5S, stainless steel heat exchanger, penumatic
damper for spraying and baking cycle, max temp: 80 degree, heating
productive: 260000Kal/h, with heat recuperator, and pipe as for
spare part to change the aluminum core plate in the summer.|
|Purification system||Pre-filter, ceiling filter, fibreglass filter, pocket filter|
|Control system||Spraying, heat spraying, baking, time setting, lighting switch,
failure indicator, temperature controller, power supply switch,
emergency stop, hour meter, temperature limiter, pressure gauge,
baking time start from the temperature up to the setting value.|
|Total Power||17KW (3×380V, 50HZ)|
|Note||With pressure sensor, if the real pressure smaller or bigger than
the setting value, the fan will stop working, fix plate use the one
switch on control box, client make the platform for air group,|